Thermon KSR-CFK Manual do Utilizador descarregar pdf (Página 3)

7. Apply a liberal amount of RTV sealant to cable.

5. Cut V-notch in matrix and pull wires from matrix.

6. Cut and remove remaining center core of matrix.

4. Skive outside edges of primary insulation and

black matrix.

Power Connection Instructions

1. Cut and remove heating cable overjacket as

shown.

Do not cut metallic braid.

2. Separate braid strands at edge of overjacket and

pull cable through opening in braid.

3. Twist braid into a pigtail. Trim ends of braid.

152 mm

(6”)

117 mm

(4.62”)

8. Slide boot onto the end of the cable.

13 mm

(.5”)

INSTALLATION PROCEDURES

Do not cut bus wire strands.

1 2 3 4 5

Sem comentários

Thermon KSR-CFK Manual do Utilizador Página 3