Thermon KSR-SK-DB Manual do Utilizador

KSR-SK-DBIn-Line Splice Kit INSTALLATION PROCEDURESKSR Snow Melting Cable

2KSR-SK-DB In-Line Splice KitTools Required . . .The following installation procedures are suggested guidelines for the installation of in-line cable

37. Apply a liberal amount of RTV sealant to cable. 5. Cut V-notch in matrix and pull wires from matrix.6. Cut and remove remaining center core of

410. Slide heat shrink 1 28mm x 325mm (1.10” x 12.80”) then heat shrink 2 20mm x 120mm (.79” X 4.72”) onto cable as shown.12. Repeat steps 1-8 f

519. Cut two pieces of mastic tape about 25mm (1”) long. Stretch mastic tape to cover the yellow cable jacket on each cable. Mastic Tape Heat Shrink

6THERMON . . . The Heat Tracing Specialists®100 Thermon Dr. • PO Box 609 • San Marcos, TX 78667-0609Phone: 512-396-5801 • Facsimile: 512-396-362