Thermon FLX Manual do Utilizador

FLX TM Self-RegulatingWinterization/Freeze ProtectionINSTALLATION PROCEDURES

Form CPD1018-1008 © Thermon Manufacturing Co. Printed in U.S.A.Thermon . . . The Heat Tracing Specialists100 Thermon Dr. • PO Box 609 • S

INSTALLATION PROCEDURESTypical Heat Tracing Installation . . .A complete electric heat tracing system will typically include the following components:

FLX TM Self-Regulating22. Make heating cable allowances for valves, flanges, elbows and supports as per the applicable drawings and table on pages 2 a

INSTALLATION PROCEDURES3Table 1: Valve and Pump AllowancesHeating Cable12” Max. (30 cm)Note:Flange allowance will vary based on method of insulating fl

FLX TM Self-Regulating4Completing the Installation . . .1. Begin final cable attachment by securing the end-of-circuit termination kit and working bac

INSTALLATION PROCEDURES5Final Inspection and Documentation . . . 1. It is recommended that the circuit be temporarily energized so that the volts, am

FLX TM Self-Regulating6Installation Guidelines for Fire Protection Systems1. Where above ground water-filled supply pipes, risers, sys-tem risers or fe

FLX ™ Cable Testing Report1. Refer to Thermon FLX Installation Procedures, FORM CPD0000, for general installation procedures, requirements and guide-

Customer: Contractor: Address: Address: Phone No: Phone No. Project Reference:Record 1: Prior to Installation Cable Type: Heater Length: